Characterization of Fe                         2                         O                         3                         /Mn                         2                         O                         3                          oxygen carrier for chemical looping combustion prepared by dry impregnation method

Nurfanizan Mohd Afandi; Abreeza Noorlina Abd Manap; Fitri Hanif Mansor; Mohammad Firdaus Abdul Ghani; N. F. Kadir; Wen Liu

doi:10.14419/ijet.v7i4.35.23087

Characterization of Fe ₂ O ₃ /Mn ₂ O ₃ oxygen carrier for chemical looping combustion prepared by dry impregnation method

Nurfanizan Mohd Afandi^*, Abreeza Noorlina Abd Manap, Fitri Hanif Mansor, Mohammad Firdaus Abdul Ghani, N. F. Kadir, Wen Liu

^*Corresponding author for this work

Research output: Contribution to journal › Article › peer-review

3 Citations (Scopus)

Abstract

Recently, bauxite waste was found as newly sourced of Fe-based oxygen carrier in chemical looping combustion (CLC) since it contains high Fe and capable to be used as oxygen carrier at low cost. This study focuses on synthesizing and characterizing the bauxite waste that found in Malaysia with Mn ₂ O ₃ using dry impregnation method and study the feasibility of this bauxite waste as oxygen carrier. Results show the combination of bauxite waste - Mn ₂ O ₃ at 900°C produces crystallite size 21 nm with the presence of Fe-Mn, stable Al ₂ O ₃ and Ti elements that can improve the reactivity of Fe-Mn oxygen carrier. Moreover, Al ₂ O ₃ that contains naturally in bauxite waste can acts as supported material for Fe-Mn oxygen carrier in order to increase performance in CLC process. Therefore, this powder was successfully synthesized using dry impregnation method at calcination temperature 900°C and fit to be tested in a fluidized bed reactor to simulate the CLC process since it has smaller and stable particle size.

Original language	English
Pages (from-to)	674-677
Number of pages	4
Journal	International Journal of Engineering and Technology(UAE)
Volume	7
Issue number	4
DOIs	https://doi.org/10.14419/ijet.v7i4.35.23087
Publication status	Published - 2018
Externally published	Yes

Bibliographical note

Publisher Copyright:
© 2018 Authors.

ASJC Scopus Subject Areas

Biotechnology
Computer Science (miscellaneous)
Environmental Engineering
General Chemical Engineering
General Engineering
Hardware and Architecture

Keywords

Bauxite waste
Dry impregnation method
Fe-based oxygen carrier
Fe-Mn

Access to Document

10.14419/ijet.v7i4.35.23087

Cite this

Afandi, N. M., Manap, A. N. A., Mansor, F. H., Ghani, M. F. A., Kadir, N. F., & Liu, W. (2018). Characterization of Fe ₂ O ₃ /Mn ₂ O ₃ oxygen carrier for chemical looping combustion prepared by dry impregnation method International Journal of Engineering and Technology(UAE), 7(4), 674-677. https://doi.org/10.14419/ijet.v7i4.35.23087

Afandi, Nurfanizan Mohd ; Manap, Abreeza Noorlina Abd ; Mansor, Fitri Hanif et al. / Characterization of Fe ₂ O ₃ /Mn ₂ O ₃ oxygen carrier for chemical looping combustion prepared by dry impregnation method In: International Journal of Engineering and Technology(UAE). 2018 ; Vol. 7, No. 4. pp. 674-677.

@article{506719a13cb84e45b592a14a8118e127,

title = " Characterization of Fe 2 O 3 /Mn 2 O 3 oxygen carrier for chemical looping combustion prepared by dry impregnation method ",

abstract = " Recently, bauxite waste was found as newly sourced of Fe-based oxygen carrier in chemical looping combustion (CLC) since it contains high Fe and capable to be used as oxygen carrier at low cost. This study focuses on synthesizing and characterizing the bauxite waste that found in Malaysia with Mn 2 O 3 using dry impregnation method and study the feasibility of this bauxite waste as oxygen carrier. Results show the combination of bauxite waste - Mn 2 O 3 at 900°C produces crystallite size 21 nm with the presence of Fe-Mn, stable Al 2 O 3 and Ti elements that can improve the reactivity of Fe-Mn oxygen carrier. Moreover, Al 2 O 3 that contains naturally in bauxite waste can acts as supported material for Fe-Mn oxygen carrier in order to increase performance in CLC process. Therefore, this powder was successfully synthesized using dry impregnation method at calcination temperature 900°C and fit to be tested in a fluidized bed reactor to simulate the CLC process since it has smaller and stable particle size.",

keywords = "Bauxite waste, Dry impregnation method, Fe-based oxygen carrier, Fe-Mn",

author = "Afandi, {Nurfanizan Mohd} and Manap, {Abreeza Noorlina Abd} and Mansor, {Fitri Hanif} and Ghani, {Mohammad Firdaus Abdul} and Kadir, {N. F.} and Wen Liu",

note = "Publisher Copyright: {\textcopyright} 2018 Authors.",

year = "2018",

doi = "10.14419/ijet.v7i4.35.23087",

language = "English",

volume = "7",

pages = "674--677",

journal = "International Journal of Engineering and Technology(UAE)",

issn = "2227-524X",

number = "4",

}

Afandi, NM, Manap, ANA, Mansor, FH, Ghani, MFA, Kadir, NF & Liu, W 2018, ' Characterization of Fe ₂ O ₃ /Mn ₂ O ₃ oxygen carrier for chemical looping combustion prepared by dry impregnation method ', International Journal of Engineering and Technology(UAE), vol. 7, no. 4, pp. 674-677. https://doi.org/10.14419/ijet.v7i4.35.23087

Characterization of Fe ₂ O ₃ /Mn ₂ O ₃ oxygen carrier for chemical looping combustion prepared by dry impregnation method . / Afandi, Nurfanizan Mohd; Manap, Abreeza Noorlina Abd; Mansor, Fitri Hanif et al.
In: International Journal of Engineering and Technology(UAE), Vol. 7, No. 4, 2018, p. 674-677.

Research output: Contribution to journal › Article › peer-review

TY - JOUR

T1 - Characterization of Fe 2 O 3 /Mn 2 O 3 oxygen carrier for chemical looping combustion prepared by dry impregnation method

AU - Afandi, Nurfanizan Mohd

AU - Manap, Abreeza Noorlina Abd

AU - Mansor, Fitri Hanif

AU - Ghani, Mohammad Firdaus Abdul

AU - Kadir, N. F.

AU - Liu, Wen

PY - 2018

Y1 - 2018

N2 - Recently, bauxite waste was found as newly sourced of Fe-based oxygen carrier in chemical looping combustion (CLC) since it contains high Fe and capable to be used as oxygen carrier at low cost. This study focuses on synthesizing and characterizing the bauxite waste that found in Malaysia with Mn 2 O 3 using dry impregnation method and study the feasibility of this bauxite waste as oxygen carrier. Results show the combination of bauxite waste - Mn 2 O 3 at 900°C produces crystallite size 21 nm with the presence of Fe-Mn, stable Al 2 O 3 and Ti elements that can improve the reactivity of Fe-Mn oxygen carrier. Moreover, Al 2 O 3 that contains naturally in bauxite waste can acts as supported material for Fe-Mn oxygen carrier in order to increase performance in CLC process. Therefore, this powder was successfully synthesized using dry impregnation method at calcination temperature 900°C and fit to be tested in a fluidized bed reactor to simulate the CLC process since it has smaller and stable particle size.

AB - Recently, bauxite waste was found as newly sourced of Fe-based oxygen carrier in chemical looping combustion (CLC) since it contains high Fe and capable to be used as oxygen carrier at low cost. This study focuses on synthesizing and characterizing the bauxite waste that found in Malaysia with Mn 2 O 3 using dry impregnation method and study the feasibility of this bauxite waste as oxygen carrier. Results show the combination of bauxite waste - Mn 2 O 3 at 900°C produces crystallite size 21 nm with the presence of Fe-Mn, stable Al 2 O 3 and Ti elements that can improve the reactivity of Fe-Mn oxygen carrier. Moreover, Al 2 O 3 that contains naturally in bauxite waste can acts as supported material for Fe-Mn oxygen carrier in order to increase performance in CLC process. Therefore, this powder was successfully synthesized using dry impregnation method at calcination temperature 900°C and fit to be tested in a fluidized bed reactor to simulate the CLC process since it has smaller and stable particle size.

KW - Bauxite waste

KW - Dry impregnation method

KW - Fe-based oxygen carrier

KW - Fe-Mn

UR - http://www.scopus.com/inward/record.url?scp=85059236635&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85059236635&partnerID=8YFLogxK

U2 - 10.14419/ijet.v7i4.35.23087

DO - 10.14419/ijet.v7i4.35.23087

M3 - Article

AN - SCOPUS:85059236635

SN - 2227-524X

VL - 7

SP - 674

EP - 677

JO - International Journal of Engineering and Technology(UAE)

JF - International Journal of Engineering and Technology(UAE)

IS - 4

ER -

Afandi NM, Manap ANA, Mansor FH, Ghani MFA, Kadir NF, Liu W. Characterization of Fe ₂ O ₃ /Mn ₂ O ₃ oxygen carrier for chemical looping combustion prepared by dry impregnation method International Journal of Engineering and Technology(UAE). 2018;7(4):674-677. doi: 10.14419/ijet.v7i4.35.23087